Large Steam 1100mm Turbine Rotor Forging 30Cr1Mo1V Power 10Mw
- Steam turbine generator, water generator rotor, turbine shaft,
steam turbine axle, forged turbine axle
- General material: 25Cr2Ni4MoV, 30CrNi4Mo, 34CrNi3Mo, 30Cr1Mo1V
- Mainly applied in manufacturing power generation equipment
1. With character of high strength, high temperature resistance and
high corrosion-resistance, the middle pressure steam turbine main
shaft could be mainly used in power generation equipment.
2. It could be rough machined or finish machined based on drawing
or customers’ demand.
3. Full reports of chemical analysis, dimensions, UT, mechanical
properties will be sent before delivery.
Turbine rotor is mainly used in large and small gas turbine unit
EF+ LF + VD(double)
Forging & machining process
(Normalizing+tempering)→Inspection→Rough machining→UT→2nd Heat
treatment →Finished machining →Inspection